Cable voltage drop calculator
Estimate voltage drop on a copper radial circuit using length, current and cable size. Compare the project limit and the corrected cable capacity.
United Kingdom · Choose an edition
Calculation method
Enter the one way cable length and the conductor cross section. The calculation uses circuit voltage for single phase and voltage between phases for balanced three phase.
Deduct the upstream voltage drop from the project limit. Check the entered cross section against both the remaining voltage drop allowance and its corrected current capacity.
Continue the calculation with Adiabatic protective conductor calculator, Three-phase neutral current calculator, Cable current derating calculator, Conduit fill ratio calculator, Cable bend radius calculator, Short circuit breaking capacity comparison, Earth fault loop current worksheet, EV charging cable heat loss calculator, Three-phase equipment worksheet.
Method and assumptions
- The minimum cross section shown is for voltage drop only. Cable selection also needs installation conditions, protection, fault current, disconnection times and applicable local rules.
- Ring circuits are outside this model. The entered corrected current capacity must match the cable size and installation being assessed.
Sources
Local reference: BS 7671:2018+A4:2026. References checked on: 17 November 2026.
- IET — Current edition of BS 7671
- IET — Electric vehicle charging installations
- IET — Voltage drop and EV charging
- SELECT — Amendment 4:2026